5
REAR PANEL, LEFT TO RIGHT
1.
MAINS FUSE
– Protection for AC power faults.
2.
MAINS INPUT
– AC wall power via IEC cord to a grounded outlet.
3.
HT FUSE
– Protection for high voltage faults.
4.
MIDI IN* –
Connects to external device via MIDI OUT or THRU. 7 connector with
outside pin 1 and pin 7 supplying 9VAC at 1.5A to power external Midi pedals.
5.
MIDI THRU* –
Routes Midi to other devices.
6.
FOOTSWITCH* –
Connect your footswitch here.
7.
BIAS CONTROLS
– Bias adjust pots and test points. Tubes fused in pairs at T.5A.
8.
S.LEVEL* –
FX loop send level.
9.
FX LOOP* –
FX loop on or off.
10.
SEND* –
Send jack connects to effects input.
11.
SERIES/ PARALLEL* –
Selects the FX loop operation.
12.
RETURN* –
Return jack connects to effects output.
13.
LEVEL L / H* –
Sets recovery gain structure for FX Loop. Set to L for rack effects
and H for stomp box pedals.
14.
R.LEVEL* –
Effects level in SERIES and effects mix in PARALLEL.
15.
LINEOUT* –
Unbalanced signal tapped off the output transformer. Use a shielded
cable to send a signal to the effects rack, mixer input, or to another amp’s input or
effects return to slave.
16.
LEVEL* –
Lineout adjustable line level.
17.
LOUDSPEAKERS
- Paralleled wired jacks for 1 or 2 - 16 ohm, 1 or 2 - 8 ohm and
single 4 ohm cabinets.
*
Optional
