Plug in the
on the PASSLOCK-SL2
interface.
connector 1
(black)
1
Press and hold the programming
button. Plug the
into the PASSLOCK-SL2
interface.
connector 2
(white)
2
WIRING / CONNECTION GUIDE
See wiring schematic configuration
BYPASS MODULE FOR PASSLOCK I AND PASSLOCK II, SATURN, HUMMER H2, VATS AND NEW GENERATION
PASSLOCK-SL2
P.1
1
1.A
1.B
8
9
10
You have 4 seconds to:
IGN
START
OFF
2
1
12V Batterie
(+)
Data-Link
Data-Link
Red
Black
Blue
White
(-) While running
Data In Barillet
Data from BCM
Bulb test Out
Key sense Out
Starter or accessory
Green
Blue
Orange/Black
Orange
Purple/White
Purple
Yellow/Black
Ignition or accessory
Yellow
2
3
4
5
6
7
INSTALLATION WITH DATA-LINK
INSTALLATION WITHOUT DATA-LINK
INSTALLATION WITHOUT DATA-LINK
Starter or alarm
Data Link Port
1
Plan 1
Starter or alarm
2
1
Red
+12V
Plan 2
TECHNICAL SUPPORT / INFORMATION
INPUT
OUTPUT
Connect wire to
vehicle
Connect wire to Remote-
Starter/Alarm
START HERE
INSTALLATION AND PROGRAMMATION INSTRUCTIONS
Make the connections of the PASSLOCK-SL2
to the vehicle:
Connector 2 (White):
(I) Locate the wiring type for the vehicle on the
VEHICLE FIT GUIDE (P.3)
(II) Make the connections associated with the vehicle in the
WIRING SCHEMATIC CONFIGURATION (P.3)
The LED will turn on, indicating
the beginning of programming.
Turn
the
key
to
the
ignition
position.
The LED will flash rapidly.
Release the programming button.
Start the vehicle with the key.
The LED will flash (1-6 times).
Turn the key OFF.
THE PASSLOCK-SL2 IS
PROGRAMMED.
In Data-Link mode the
analog Inputs (Unlock,
ground out) are disable
for security.
Programming
Button
LED
IGN
START
OFF
IGN
START
OFF
Technical support:
Web: www.ifar.ca
TEL: 514-255-HELP (4357)
FAX: 514-255-1367
Connector 1 (Black):
Determine the type of installation:
DATA-LINK (See plan 1, Below).
INSTALLATION WITH
INSTALLATION WITHOUT DATA-LINK (See plan 2, Below).
Cut off one plug of
the Data-Link
connector, connect
the red wire to +12V
and the green wire to
ground.
Neither the manufacturer or distributor of this module is responsible of
damages of any kind indirectly or directly caused by this module, except
for the replacement of this module in case of manufacturing defects. This
module must be install by qualified technician. This instruction guide may
change without notice. Visit www.ifar.ca to get latest version.
Copyright © 2006, FORTIN AUTO RADIO INC - ALL RIGHTS RESERVED
2
INSTALLATION GUIDE
Made in Canada - Rev. P - 05 / 12 / 2008
W e b
s i t e :
h t t p : / / w w w . i f a r . c a
Ground (-)
N.C.
7
0
7 0 3 5 0 0 0 1 4 9
