- 659 -
11.2.8.2 Configuring SNMP Trap Receiver Configuration Page
This menu will display an entry for every active Trap Receiver.
Selection Criteria
Community
- You can use this screen to reconfigure an existing community, or to create a new one.
Use this pulldown menu to select one of the existing community names, or select 'Create' to add a
new one.
SNMP Version
- Select the trap version to be used by the receiver from the pull down menu:
SNMP v1 - Uses SNMP v1 to send traps to the receiver.
SNMP v2 - Uses SNMP v2 to send traps to the receiver.
Status
- Select the receiver's status from the pulldown menu:
Enable - send traps to the receiver.
Disable - do not send traps to the receiver.
Configurable Data
SNMP Community Name
- Enter the community string for the SNMP trap packet to be sent to the
trap manager. This may be up to 16 characters and is case sensitive.
IP Address
- Enter the IP address to receive SNMP traps from this device. Enter 4 numbers
between 0 and 255 separated by periods.
Command Buttons
Submit
- Update the switch with the values on this screen. If you want the switch to retain the new
values across a power cycle, you must perform a save.
Delete
- Delete the currently selected Community Name. If you want the switch to retain the new
values across a power cycle, you must perform a save.
Summary of Contents for 548B
Page 1: ...FortiSwitch 548B Version 5 2 0 2 Administration Guide...
Page 492: ...492 Default Setting Decrement 10 Command Mode Interface Config...
Page 869: ...869...
Page 976: ...www fortinet com...
