- 677 -
Selection Criteria
IPv4 Address
- Select the way "IPv4 Address" to trace.
Host Name
- Select the way "host name" to trace.
Host Name V6
- Select the way "Host Name V6" to trace.
IPv6 Address
- Select the way "IPv6 Address" to trace.
Configurable Data
IP Address
- Enter the IP address of the station you want the switch to discover path. The initial
value is blank. The IP Address you enter is not retained across a power cycle.
Probes Per Hop
- Enter the number of probes per hop. The initial value is default. The Probes per
Hop you enter is not retained across a power cycle.
MaxTTL
- Enter the maximum TTL for the destination. The initial value is default value. The MaxTTL
you enter is not retained across a power cycle.
InitTTL
- Enter the initial TTL to be used. The initial value is default value. The InitTTL you enter is
not retained across a power cycle.
MaxFail
- Enter the maximum Failures allowed in the session. The initial value is default value. The
MaxFail you enter is not retained across a power cycle.
Interval
- Enter the Time between probes in seconds. The initial value is default value. The Interval
you enter is not retained across a power cycle.
Traceroute
- Display the result of traceroute.
Command Buttons
Submit -
This will initiate the traceroute.
Summary of Contents for 548B
Page 1: ...FortiSwitch 548B Version 5 2 0 2 Administration Guide...
Page 492: ...492 Default Setting Decrement 10 Command Mode Interface Config...
Page 869: ...869...
Page 976: ...www fortinet com...
