© Copyright 2007 Fortinet Incorporated. All rights reserved.
Products mentioned in this document are trademarks or registered trade-
marks of their respective holders.
Regulatory Compliance
FCC Class A Part 15 CSA/CUS
31 July 2007
Checking the Package Contents
Connecting
Planning the Configuration
Back
Ethernet Network
Connections
SCSI Connector
For Tape Drive
For Future Use
RS-232
Serial
Connection
ATX Redundant
Power Supplies
Power
Connection
Power
Switch
Ethernet Cables:
Orange - Crossover
Grey - Straight-through
Documentation
FortiAnalyzer-800
Copyright 2006 Fortinet Incorporated. All rights reserved.
Trademarks
Products mentioned in this document are trademarks.
Power Cable
Null-Modem Cable
(RS-232)
Front
LCD
Panel
Hard Disk
LEDs
Setting
Switches
A and B
LED indicators:
Power, Error, Network,
and Disk Access
Hard Disk
LEDs
Q u i c k S t a r t G u i d e
Straight-through Ethernet cable connects
to hub or switch on the network
Null modem cable connects
to serial port on management computer
Power cable connects to power outlet
Place the FortiAnalyzer unit on a stable surface. It requires 1.5 inches (3.75 cm) clearance
on each side to allow for cooling.
Make sure the power is not plugged into the wall before connecting the power cable.
The Status light flashes while the unit is starting up and remains lit when the system is up
and running.
•
•
•
Connect the FortiAnalyzer unit to a power outlet and to the network hub or switch.
FortiAnalyzer-800
05-30005-0224-20070731
FortiAnalyzer Unit LED Indicators
Light Icon
Description
The FortiAnalyzer power indicator. The FortiAnalyzer unit is powered on
when the light is on.
LED currently not in use.
Network activity. The light flashes as network activity is occurring on the
FortiAnalyzer unit.
Hard disk activity. The light flashes as log packets are written to the For
-
tiAnalyzer hard disk, and when the FortiAnalyzer unit accesses the hard
disk to generate reports.
Connector
Type
Speed
Protocol
Description
Ports 1 and 2
RJ-45
10/100Base-T
Ethernet
Connection to the network
CONSOLE
DB-9
9600 bps
RS-232 serial Connection to the management computer. Provides
access to the command line interface (CLI).
You can add the FortiAnalyzer unit to your local FortiGate network to receive log messages
from your local FortiGate units, or connect the FortiAnalyzer unit to the FortiGate units re-
motely using FortiManager. To connect the FortiAnalyzer unit to the FortiGate units remotely,
you must configure the DNS server and the default gateway.
To manage the FortiAnalyzer unit, you can use a computer within the local network or over
the Internet.
Factory Defaults
Administrator Account
User name:
admin
Password:
(none)
Port 1
IP:
192.168.1.99
Netmask:
255.255.255.0
Management Access:
ping, https, http, ssh
Port 2
IP:
192.168.2.99
Netmask:
255.255.255.0
Management Access:
ping, https, http, ssh
