FortiGate-50A/50B, FortiWiFi-50B and FortiGate-100 FortiOS 3.0 MR4 Install Guide
40
01-30004-0265-20070831
NAT/Route mode installation
Configuring the FortiGate unit
config system interface
edit <interface>
set mode static
set ip <address_ip> <netmask>
end
Example
config system interface
edit internal
set mode static
set ip 192.168.120.99 255.255.255.0
end
3
Set the IP address and netmask of the external interface to the external IP
address and netmask you recorded in
Table 12 on page 36
.
config system interface
edit <interface>
set mode static
set ip <address_ip> <netmask>
end
Example
config system interface
edit external
set mode static
set ip 10.10.1.5 255.255.255.0
end
To set the external interface to use DHCP, enter:
config system interface
edit <interface>
set mode dhcp
end
To set the external interface to use PPPoE, enter:
config system interface
edit <interface>
set mode pppoe
set connection enable
set username <name_str>
set password <psswrd>
end
4
Use the same syntax to set the IP address of each FortiGate interface as required.
5
Confirm that the addresses are correct. Enter:
get system interface
The CLI lists the IP address, netmask, and other settings for each of the FortiGate
interfaces.
To configure DNS server settings
Set the primary and secondary DNS server IP addresses. Enter
Summary of Contents for Fortigate 100D
Page 83: ...www fortinet com ...
Page 84: ...www fortinet com ...
