Getting started
Factory default FortiGate configuration settings
FortiGate-3000 Installation Guide
01-28005-0026-20041101
19
Factory default Transparent mode network configuration
In Transparent mode, the FortiGate unit has the default network configuration listed in
Table 3
.
Factory default firewall configuration
FortiGate firewall policies control how all traffic is processed by the FortiGate unit.
Until firewall policies are added, no traffic can be accepted by or pass through the
FortiGate unit. To allow traffic through the FortiGate unit you can add firewall policies.
See the
FortiGate Administration Guide
for information about adding firewall policies.
The following firewall configuration settings are included in the default firewall
configuration to make it easier to add firewall policies.
The factory default firewall configuration is the same in NAT/Route and Transparent
mode.
Table 3: Factory default Transparent mode network configuration
Administrator
account
User name:
admin
Password:
(none)
Management IP
IP:
10.10.10.1
Netmask:
255.255.255.0
DNS
Primary DNS Server:
207.194.200.1
Secondary DNS Server:
207.194.200.129
Administrative access
Internal
HTTPS, Ping
External
Ping
Port 1
HTTPS, Ping
Port 2
Ping
Port 3
Ping
Port 4/HA
Ping
Table 4: Default firewall configuration
Configuration setting Name
Description
Firewall address
All
Firewall address matches the source or
destination address of any packet.
Pre-defined service
More than 50
predefined services
Select from any of the 50 pre-defined services
to control traffic through the FortiGate unit that
uses that service.
Recurring schedule
Always
The recurring schedule is valid at any time.
Protection Profiles
Strict, Scan, Web,
Unfiltered
Control how the FortiGate unit applies virus
scanning, web content filtering, spam filtering,
and IPS.
