FortiGate-5001D mounting components
Hardware installation
FortiGate-5001D Security System Guide
16
01-500-0242101-20151109
http://docs.fortinet.com/
1
Attach the ESD wrist strap to your wrist and to an available ESD socket or wrist strap
terminal.
2
If you have installed the FortiGate-5001D board in a chassis, remove it.
For removal instructions, see
“Shutting down and removing a FortiGate-5001D board”
on page 19
.
3
Use
Figure 3 on page 14
to locate SW6 on the FortiGate-5001D board.
4
If required, change SW6 to the correct setting.
5
Insert the FortiGate-5001D board into a chassis and verify that the board starts up
and operates correctly.
For inserting instructions, see
“Inserting a FortiGate-5001D board” on page 17
.
FortiGate-5001D mounting components
To install a FortiGate-5001D board you slide the board into an open slot in the front of an
ATCA chassis and then use the mounting components to lock the board into place in the
slot. When locked into place and positioned correctly the board front panel is flush with
the chassis front panel. The board is also connected to the chassis backplane.
To position the board correctly you must use the mounting components shown in
Figure 6
for the right (bottom) side of the front panel. The mounting components on the
left (top) side of the FortiGate-5001D front panel are the same but reversed. The
FortiGate-5001D mounting components align the board in the chassis slot and are used
to insert and eject the board from the slot.
Figure 6: FortiGate-5001D right (bottom) mounting components
FortiGate-5001D boards are horizontal when inserted into a FortiGate-5060 chassis and
vertical when inserted into a FortiGate-5140 chassis. The inserting and removing
procedures are the same in either case. For clarity the descriptions in this document
refer to the left (top) and right (bottom) mounting components.
Clo
s
ed
Open
Alignment
Pin
Retention
S
crew
Lock
Handle
Alignment Pin
Retention
S
crew
Lock
Handle
Handle
Hook
Alignment Pin
Retention
S
crew
Lock
Hook
Alignment
Pin
Retention
S
crew
Lock
Handle
