FortiGate-5001FA2-LENC Security System Guide
6
01-30000-76602-20080606
Front panel LEDs and connectors
FortiGate-5001FA2-LENC security system
• Mounting hardware
• LED status indicators
The FortiGate-5001FA2-LENC board comes supplied with four optical or four
copper SFP transceivers. Before you can connect FortiGate-5001FA2-LENC
interfaces 1 to 4, you must insert the SFP transceivers into the
FortiGate-5001FA2-LENC front panel cage slots numbered 1 to 4.
The FortiGate-5001FA2-LENC board ships with two RAM DIMMs installed on the
FortiGate-5001FA2-LENC circuit board. You should confirm that the RAM DIMMs
are installed correctly before inserting the FortiGate-5001FA2-LENC board into a
chassis.
Front panel LEDs and connectors
From the FortiGate-5001FA2-LENC font panel you can view the status of the front
panel LEDs to verify that the board is functioning normally. You also connect the
FortiGate-5001FA2-LENC board to your network through the front panel ethernet
connectors. The front panel also includes the RS-232 console port for connecting
to the FortiOS CLI and a USB port. The USB port can be used with a Fortinet USB
key. For information about using the FortiUSB key, see the
FortiGate-5000 Series
Firmware and FortiUSB Guide
.
LEDs
Table 1
lists and describes the FortiGate-5001FA2-LENC board LEDs.
Table 1: FortiGate-5001FA2-LENC board LEDs
LED
State
Description
PWR
Green
The FortiGate-50012FA2 board is powered on.
ACC
Off or
Flashing
red
The ACC LED flashes red when the
FortiGate-5001FA2-LENC board accesses the FortiOS flash
disk. The FortiOS flash disk stores the current FortiOS
firmware build and configuration files. The system accesses
the flash disk when starting up, during a firmware upgrade, or
when an administrator is using the CLI or GUI to change the
FortiOS configuration. Under normal operating conditions this
LED flashes occasionally, but is mostly off.
STA
Green
Normal operation.
Red
The FortiGate-5001FA2-LENC is booting or a fault condition
exists.
IPM
Blue
The FortiGate-5001FA2-LENC is ready to be hot-swapped
(removed from the chassis). If the IPM light is blue and no
other LEDs are lit the FortiGate-5001FA2-LENC board has
lost power, possibly because of a loose or incorrectly aligned
left handle. See
“Inserting a FortiGate-5001FA2-LENC board
into a chassis” on page 13
for more information.
Flashing
Blue
The FortiGate-5001FA2-LENC is changing from hot swap to
running mode or from running mode to hot swap.
Off
Normal operation. The FortiGate-5001FA2-LENC board is in
contact with the chassis backplane.
1, 2, 3, 4
Green
The correct cable is connected to the gigabit SFP interface.
Flashing
Network activity at the gigabit SFP interface.
