Using the shelf manager CLI
Shelf manager CLI commands
FortiGate-5140B Chassis Guide
01-500-156415-20151104
45
fru
clia fru [-v] [<IPMB_address> [id=<fru_device_id> |
type=<site_type>]] | [type=<site_type> [/<site_number>]]
This command displays information about a specific FRU. If
<FRU_device_ID>
is
omitted, the command shows information about all FRUs controlled by the IPM controller
at the specified address. If
<IPMB_address>
is also omitted, the command displays
information about all FRUs known to the shelf manager.
Display information for all FRUs
Enter the following command to display all of the FRUs at IPMB address 20 (fans, PEMs,
and so on):
# clia fru 14
Pigeon Point Shelf Manager Command Line Interpreter
14: FRU # 0
Entity: (0xf1, 0x60)
Hot Swap State: M4 (Active), Previous: M3 (Activation In
Process), Last State Change Cause: Normal State Change
(0x0)
Device ID String: "SFRU Alarm Board"
14: FRU # 1
Entity: (0xf2, 0x60)
Hot Swap State: M4 (Active), Previous: M3 (Activation In
Process), Last State Change Cause: Normal State Change
(0x0)
Device ID String: "Shelf FRU Data"
14: FRU # 2
Entity: (0xf3, 0x60)
Hot Swap State: M4 (Active), Previous: M3 (Activation In
Process), Last State Change Cause: Normal State Change
(0x0)
Device ID String: "Telco Alarm"
For information about hot swap states, see
Display information for a specific FRU
# clia fru 90
Pigeon Point Shelf Manager Command Line Interpreter
90: FRU # 0
Entity: (0xa0, 0x60)
Hot Swap State: M4 (Active), Previous: M4 (Active), Last State
Change Cause: Normal State Change (0x0)
Device ID String: "FG5005A"
fruinfo
clia fruinfo [-v] [-x]<addr> <fru_id>
This command displays FRU Information in a user-friendly format.
