Using the shelf manager CLI
Basic shelf manager CLI Commands
FortiGate-5140B Chassis Guide
01-500-156415-20151104
39
Basic shelf manager CLI Commands
From the chassis shelf manager CLI you can view system information, FRU information
and sensor data with the following basic commands. If your chassis has two shelf
managers, you must connect to the active shelf manager to access sensor data.
Change IP address of the primary Shelf Manager
The default IP address of the primary shelf manager is 192.168.0.2. Use the following
command to change this IP address.
# clia setlanconfig <channel> ip <ip_address>
<channel>
is the shelf manager channel and can be 1 or 2.
<ip_address>
is the new
IP address in dotted decimal notation. For example:
# clia setlanconfig 1 ip 192.168.0.2
Display the shelf manager firmware version
# clia version
To display a complete list of all information enter
version
with no other parameters.
List all FRUs in the chassis
# clia fru
List all sensors on a FRU
# clia sensor <IPMB_address>
List only sensors that are outside of established thresholds
# clia sensor -t
Display sensor data for a FRU
# clia sensordata <IPMB_address> <sensor_number>
ATCA logical slot 4
88
44
ATCA logical slot 5
8A
45
ATCA logical slot 6
8C
46
ATCA logical slot 7
8E
47
ATCA logical slot 8
90
48
ATCA logical slot 9
92
49
ATCA logical slot 10
94
4A
ATCA logical slot 11
96
4B
ATCA logical slot 12
98
4C
ATCA logical slot 13
9A
4D
ATCA logical slot 14
9C
4E
Table 8: FortiGate-5140B chassis component FRU names, IPMB addresses, and
hardware addresses (Continued)
FRU name
IPMB
address (hex)
Hardware
Address (hex)
