System config
HA configuration
FortiGate-100A Administration Guide
01-28006-0068-20041105
87
Unit Priority
Optionally set the unit priority of the cluster unit. Each cluster unit can have a different
unit priority (the unit priority is not synchronized among cluster members). During HA
negotiation, the unit with the highest unit priority becomes the primary cluster unit. The
unit priority range is 0 to 255. The default unit priority is 128.
You can use the unit priority to control the order in which cluster units become the
primary cluster unit when a cluster unit fails. For example, if you have three
FortiGate-3600s in a cluster you can set the unit priorities as shown in
Table 4
. Cluster
unit A will always be the primary cluster unit because it has the highest priority. If
cluster unit A fails, cluster unit B becomes the primary cluster unit because cluster unit
B has a higher unit priority than cluster unit C.
The unit priority is not synchronized to all cluster units. Each cluster unit can have a
different unit priority.
In a functioning cluster, if you change the unit priority of the current primary cluster unit
to a lower priority, when the cluster renegotiates a different cluster unit becomes the
primary cluster unit.
Override Master
Configure a cluster unit to always override the current primary cluster unit and become
the primary cluster unit. Enable override master for the cluster unit that you have given
the highest unit priority. Enabling Override Master means that this cluster unit always
becomes the primary cluster unit.
In a typical FortiGate cluster configuration, the primary unit is selected automatically.
In some situations, you might want to control which unit becomes the primary unit. You
can configure a FortiGate unit as the permanent primary unit by setting a high unit
priority and by selecting override master. With this configuration, the same cluster unit
always becomes the primary cluster unit.
If override master is enabled and the primary cluster unit fails another cluster unit
becomes the primary unit. When the cluster unit with override master enabled rejoins
the cluster it overrides the current primary unit and becomes the new primary unit.
When this override occurs, all communication sessions through the cluster are lost
and must be re-established.
Override master is not synchronized to all cluster units.
In a functioning cluster, if you select override master for a cluster unit the cluster
negotiates and may select a new primary cluster unit.
Table 4: Example unit priorities for a cluster of three cluster units
Cluster unit
Unit priority
A
200
B
100
C
50
Summary of Contents for FortiGate FortiGate-100A
