FortiGate-5001A Security System Guide
12
01-30000-0438-200800801
FortiGate-5001A mounting components
Hardware installation
FortiGate-5001A mounting components
To install a FortiGate-5001A board you slide the board into an open slot in the
front of an ATCA chassis and then use the mounting components to lock the
board into place in the slot. When locked into place and positioned correctly the
board front panel is flush with the chassis front panel. The board is also connected
to the chassis backplane.
To position the board correctly you must use the mounting components shown in
Figure 6
for the right side of the front panel and
Figure 7
for the left side of the
front panel.
Figure 6: FortiGate-5001A mounting components (right handle)
Figure 7: FortiGate-5001A mounting components (left handle)
Closed
Open
Alignment
Pin
Retention
Screw
Lock
Handle
Alignment Pin
Retention
Screw
Lock
Handle
Handle
Hook
(right handle
only)
Alignment Pin
Retention
Screw
Lock
Hook
(right handle
only)
Alignment
Pin
Retention
Screw
Lock
Handle
Note:
The right handle includes a hook that secures the handle into place when the board
is mounted in the chassis (
Figure 6
). The hook is not included on the left handle (
Figure 7
).
Otherwise the left and right mounting components are the same. Operating the left and
right handles is also basically the same except that without the hook you do not have to
squeeze the left handle lock. Also the left handle does not lock into place in the same way
as the right handle.
Alignment
Pin
Retention
Screw
Lock
AMC Slot
Filler
Handle
