Factory defaults
FortiGate-5000 series Installation Guide
01-28011-0259-20060210
59
Transparent mode network configuration
In Transparent mode, the FortiGate-5000 module has the default network
configuration listed in
Table 8
.
Firewall configuration
FortiGate firewall policies control how all traffic is processed by the FortiGate-5000
module. Until firewall policies are added, no traffic can be accepted by or pass through
the FortiGate-5000 module. To allow traffic through the FortiGate-5000 module you
can add firewall policies. See the
FortiGate Administration Guide
for information about
adding firewall policies.
The following firewall configuration settings are included in the default firewall
configuration to make it easier to add firewall policies.
The factory default firewall configuration is the same in NAT/Route and Transparent
mode.
Table 8: Factory default Transparent mode network configuration
Administrator
account
User name:
admin
Password:
(none)
Management IP
IP:
10.10.10.1
Netmask:
255.255.255.0
DNS
Primary DNS Server:
207.194.200.1
Secondary DNS Server:
207.194.200.129
Administrative access
Port 1
HTTPS, Ping
Port 2
Ping
Port 3
Ping
Port 4
Ping
Port 5
Ping
Port 6
Ping
Port 7
(FortiGate-5001SX and
FortiGate-5001FA2 only)
Ping
Port 8
(FortiGate-5001SX and
FortiGate-5001FA2 only)
Ping
Table 9: Default firewall configuration
Configuration setting Name
Description
Firewall address
All
Firewall address matches the source or
destination address of any packet.
Pre-defined service
More than 50
predefined services
Select from any of the 50 pre-defined services
to control traffic through the FortiGate-5000
module that uses that service.
Recurring schedule
Always
The recurring schedule is valid at any time.
Protection Profiles
Strict, Scan, Web,
Unfiltered
Control how the FortiGate-5000 module
applies virus scanning, web content filtering,
spam filtering, and IPS.
