FortiGate-ASM-FB4 Version 1.0 Technical Note
12
01-30005-0424-20071002
SFP network interfaces
FortiGate-ASM-FB4 hardware
6
Apply moderate force to the front faceplate near the upper edge to secure the
module in the slot.
7
Press the latch to lock the module.
8
Power on the FortiGate unit.
To remove a FortiGate-ASM-FB4 module
1
Power off the FortiGate unit.
2
Attach the ESD wrist or ankle strap to your wrist or ankle and to an ESD socket or
to a bare metal surface on the chassis or frame.
3
Pull the latch on the FortiGate-ASM-FB4 module into the extended position. This
unlocks the module from the FortiGate unit.
4
Gently pull the latch to remove the module.
SFP network interfaces
FortiGate-ASM-FB4 modules support both SerDes and SGMII type SFP
transceivers.
Dynamic SFP media type probing is not currently supported. Use the following
command to configure the SFP media type:
config system interface
edit AMC-SW1/1
set mediatype {serdes | sgmii}
end
The default value is
serdes
.
SerDes SFP transceivers support only the fixed speed of 1Gbps; SGMII supports
tri-speed mode (10/100/1000 Mbps). Because forcing speed could result in link
failure and disrupted service, Fortinet recommends enabling link speed auto-
negotiation.
config system interface
edit AMC-SW1/1
set speed auto
end
