Rack Installation Instructions
FortiManager-1000C™ Version 4.0 Rack and Hardware Install Guide
8
02-40000-112634-20091026
Figure 2: Installing and removing the rails (square-hole racks)
•
Align each end piece to seat the pegs in the bottom hole of the first U and the top
hole of the first U (6).
•
Engage the back end of the rail until it fully seats on the vertical rack flange and the
second “tooth” on the latch locks in place. Repeat these steps to position and seat
the front end piece on the vertical flange (7).
•
To remove the rails, pull on the latch release button on the end piece midpoint and
unseat each rail (8).
3
To install the rails in round-hole racks, do the following:
•
Position the left and right rail end pieces of the rail module labeled FRONT facing
inward and orient each end piece to seat in the round holes on the front side of the
vertical rack flanges (9).
5
8
7
6
Summary of Contents for FortiManager-1000C
Page 1: ...FortiManager 1000C Version 4 0 Rack and Hardware Install Guide...
Page 31: ...www fortinet com...
Page 32: ...www fortinet com...
