Rack Installation Instructions
FortiManager-1000C™ Version 4.0 Rack and Hardware Install Guide
02-40000-112634-20091026
9
•
Figure 3: Installing and removing the rails (round-hole racks)
•
Align each end piece to seat the pegs in the bottom hole of the first U and the top
hole of the first U (10).
•
Engage the back end of the rail until it fully seats on the vertical rack flange and the
first “tooth” on the latch locks in place. Repeat these steps to position and seat the
front end piece on the vertical flange (11).
•
To remove the rails, pull on the latch release button on the end piece midpoint and
unseat each rail (12).
4
To install and remove the chassis rail members, do the following:
•
Place the system on a level surface and align the four keyhole slots on the chassis
rail members with the corresponding pins on the system (13).
9
10
11
12
Summary of Contents for FortiManager-1000C
Page 1: ...FortiManager 1000C Version 4 0 Rack and Hardware Install Guide...
Page 31: ...www fortinet com...
Page 32: ...www fortinet com...