Rack Installation Instructions
Cable Management Arm Installation
FortiManager-1000C™ Version 4.0 Rack and Hardware Install Guide
02-40000-112634-20091026
15
•
To install the cable management arm
1
Locate the components for installing the Cable Management Arm (CMA) assembly:
•
Cable Management Arm tray (1)
•
Cable Management Arm (2)
•
Nylon cable tie wraps (3)
Figure 10: Cable Management Arm kit contents
2
To install or remove the Cable Management Arm Tray, do the following:
•
Align and engage each side of the tray with the receiver brackets on the inner
edges of the rails and push forward until the tray clicks into place (4).
1
2
3
Note:
To secure the CMA for shipment in the rack, loop the tie wraps around both baskets
and tray and cinch them firmly. For larger CMAs, the tie wraps can be threaded through the
inner and outer baskets and around the tray to secure them. Securing the CMA in this
manner will also secure your system in unstable environments.
Note:
The CMA tray provides support and acts as a retainer for the CMA.
Summary of Contents for FortiManager-1000C
Page 1: ...FortiManager 1000C Version 4 0 Rack and Hardware Install Guide...
Page 31: ...www fortinet com...
Page 32: ...www fortinet com...