6
OPERATION INSTRUCTION
Notes:
1.
Sort out the articles to be ironed according to the type of fabric. This will minimize the
frequency of temperature adjustment for different garments.
2.
Test ironing a small area on the backside or inside the garment if you are unsure about the
type of fabric. Start with low temperature and increase gradually.
3.
Delicate fabrics such as silk, wool, velour and, etc, are suggested to be ironed with an ironing
cloth to prevent shine marks.
4.
To iron without an ironing board, you can spread a towel on a firm flat surface. Please ensure
that the surface is heat and moisture resistance. Do not use glass or plastic.
5.
Read the garment labels and follow the manufacturer’s ironing instructions that are often
shown by symbols similar as follows:
Voltage Switch
The appliance is a dual-voltage design and it can be used in 110-120V or 220-240V.
Please ensure the local power supply voltage is the same as the rating marked on the voltage
switch of the appliance.
For using in Hong Kong and Macau: Please ensure to turn the main voltage switch to “220V
240V” position before each use.
How to Fill Water
Note: Please unplug the appliance from the mains supply and allow it to cool down completely.
1.
Hold the handle of bottom part and pull out the Water Tank. (Fig. 1)
2.
Release the water inlet cover, and fill up with water. (Fig. 2)
3.
Replace the water inlet cover.
4.
Clean the spilt water with a dry cloth.
5.
Reattach the Water Tank by sliding on the handle of the appliance until it locks in place firmly. (Fig. 3)
(1)
(2)
(3)
