17
Fortress S-Series
FIG.5.5
FIG.5.6
FIG.5.7
5.2. ANtI-tIP WHeelS:
These are factory fitted and should not be removed.
The anti-tip assembly is bolted to the rear frame of the
scooter, (FIG.5.8).
WArNING
!
Never use the scooter without the anti-tip wheels fitted.
FIG.5.8
removing the Armrests,
(FIG.5.1).
Loosen the two hand wheels, (A) and pull the armrests
completely out of the receiver assembly. Store in a safe
place
Seat rotate lever
(FIG.5.2): This is found under the
right side of the seat. Push it forwards to allow the seat to
rotate 360 degree and release to lock in any 45 degree
position desired.
Seat Height Adjustment:
(FIG.5.3) The seat post is
height adjustable, providing 3 height positions. Carefully
unscrew the bolt and nut, and insert into desirable
position and tighten nut to a torque value of 25 Nm.
Sliding Mechanism
(FIG.5.4): This allows forward and
backward movement of the seat. Pull up lever found on
the right of the seat and use legs and body to move to
the required position and release lever.
Seat removal
(FIG.5.5 - 5.8)
1. Push the seat rotate lever forwards and turn seat 45°.
2. Stand behind the seat, flip up the arm rests and
fold the backrest forward by lifting up the backrest
adjustment lever.
4. Place hands on either side of seat base, push the seat
rotate lever forwards and lift the seat vertically keeping
back posture upright. Bend the knees if required.
WArNING
!
The seat is heavy, (35 kg/77 lbs.). Please seek
assistance.
