User
manual
—————————————————————————————————————–———
———————————————————————————–––––––––––––––––––––––––
Operating Manual Skiving Machine ES 50-UK-V3/24.01.2012
32 von 45
2.2.6
Opening for blunting and deburring the bell knife
Deburring the knife is absolutely mandatory to obtain a satisfactory
separation cut. This opening is required for blunting the knife and/or
for deburring its inside by means of the supplied oil stone. Please
refer to Chapter 1.1.5
Tools and
accessories (page 10).
The blunting of the knife
must
principally be carried out for all work
that is described in this Operating Manual prior to opening the cover.
Exceptions can only be made when it is specially pointed out in this
Operating Manual.
2.2.7
Adjusting screw for adjusting the contact pressure of
the feed roll
The contact pressure of the feed roll is adjusted by means of this
adjusting screw (1). The contact pressure is increased by turning the
adjusting screw in a clockwise direction, whereas it is reduced by
turning the adjusting screw in a counterclockwise direction.
2.2.8
Adjusting screw for adjusting the feed roll distance
The distance between the feed roll and the knife edge is reduced or
increased with this adjusting screw (2).
The following reference values must be observed
Emery feed roll
The emery feed roll should be adjusted in
parallel alignment with the knife. The
distance between the emery feed roll and
the knife is 0.1 mm.
Steel feed roll
The distance between knife edge and
feed roll should be at least 0.2 mm.
