User
manual
—————————————————————————————————————–———
———————————————————————————–––––––––––––––––––––––––
Operating Manual Skiving Machine ES 50-UK-V3/24.01.2012
33 von 45
2.2.9 Adjusting
spindle
for the knife infeed
By turning the adjusting spindle (12) of the knife infeed in a
counterclockwise direction the bell knife is moved closer to the
presser foot.
2.2.10 Setpoint
potentiometer
Use this potentiometer (16) to adjust the area in which the feed speed
can be controlled by means of the regulator pedal. Please refer to
Figure 9:
Details of the machine – front view
(page 44).
The scale shows values from 1 to 10 and in the center position (set
value: 5) it is possible to adjust the rate of feed from 0 to 100 %.
In the minimum setting (value: 0) the rate of feed can be adjusted with
the regulator pedal from 0 to 50 %.
In the maximum setting (value: 10) the rate of feed can be adjusted
from 50 to 100 % by means of the regulator pedal, i. e. the feed roll
turns even if the pedal is not being actuated.
2.2.11 Regulator
pedal
The regulator pedal (18) is located on the bottom below the machine.
Please refer to Figure 9:
Details of the machine – front view
(page 44).
The rate of feed can be regulated by means of this regulator pedal.
It is useful to preset the rate of feed at the setpoint potentiometer, please
refer to Chapter 2.2.10
Setpoint potentiometer
(page 33).
2.2.12 Handle
The handle is included in the tools.
With the handle the scraps can be removed easily and you can check with
it the feeding power.
Thus, the complete cover plate has not to be opened.
A: Lift-up to remove scraps / to check feeding power
B: See Chapter 2.2.7
Adjusting screw for adjusting the contact pressure of the feed roll
(Seite 32).
