1-port Mode Configuration
If you have selected 1-port mode, the default gateway setting could apply to the System Default, WAN or MANAGEMENT interface.
At this point, continue with the Forum Systems Installation Wizard.
*******************************************************
* Default Gateway Setting *
* *
* This is an optional default gateway for the *
* system that applies to either the device setting *
* or the management interface. *
*******************************************************
# Please enter: Device Gateway
# The default gateway for the system
Enter blank value for none
> 10.5.3.1
[Enter Device Gateway, and then press <enter>]
# Please enter: Gateway Interface
# Interface directed to the gateway
1 Let the System Choose for you
2 for WAN
3 for Management
>
1
[Enter the gateway interface. Press 1 to let the system choose for you, or 2 for WAN, or 3 for
Management, and then press <enter>]
*******************************************************
* DNS Name Server Configuration Settings *
* *
* These are optional DNS settings that can be applied *
* to the device. *
*******************************************************
# Please enter: Primary DNS
# The address of the primary DNS
> 10.5.2.11
[Enter Primary DNS, and then press <enter>]
# Please enter: Secondary DNS
# The address of a secondary DNS
> 10.5.2.12
[Enter Secondary DNS, and then press <enter>]
Establish Enable Mode Password
Note:
When leaving Command mode, evident by the cursor ForumOS>, you enter Enable mode, evident by the cursor ForumOS#.
********************************************************
* Enable Password *
* *
* Enable mode is a privileged mode of operation in *
* CLI that allows you to modify System settings. *
* These settings allow you to enter an enable mode *
* password that will allow an administrator to enter *
* enable mode. *
********************************************************
Note:
The Enable mode password must be unique, is case sensitive, and may be from 6 to 32 alphanumeric characters.
#Please enter: New Password
#The new enable mode password
>
<enter a password for enable mode >
#Please enter: Confirm Password
#Confirm the new enable mode password
>
<re-enter the password for enable mode >