3
Non-Power
Unit Column
(3 each)
Power
Unit Column
(1 each)
Right Runway
Your Lift Is Operated Hydraulically By
The Use Of An Electric Power Unit
Lock Lever
To Release Locks
From Latch Bars
Approach
Ramp
Assembly
(2 each)
Crossbeam Assembly
(2 each)
Base Plate
(1) On Each Column
Rear Of Lift
Left Runway Has Cylinder, Cables, Pull
Bar Assembly And Sheaves Underneath.
These Mechanical Components Are Used
To Raise And Lower The Lift. Cables Will
Also Be Routed Around Sheaves In
Crossbeam Assemblies And Up Through
All (4) Columns.
A Quick Overview Of Your Lift
Remember!
Prepare A Location For Your Lift Before You Unload It From The Truck.
Location Should Be A Level Surface.
Safety
Wear work gloves, steel toed shoes, and safety glasses during the
installation of your lift.
IMPORTANT
Avoid drug or alcohol use that will impair your
ability to install or operate your lift.
DANGER
Improper installation or improper use of
your lift could cause serious injury or death. Read installation
instructions and owner's manual thoroughly before installing or
operating your lift.
Unloading And Unpacking Your Lift
The components for your lift are heavy. The runways for these
lifts weigh in excess of 182 kg (400 lbs) each. The preferred
method for unloading your lift is by forklift.
If a forklift is not available a minimum of (4) people able to lift
57
kg
(
125 lbs) EACH
will be needed to unload and assemble your
lift.
57 kgs
125 lbs
57 kgs
125 lbs
57 kgs
125 lbs
57 kgs
125 lbs
CAUTION
Shipping bands around packages are under
extreme tension. Have everyone stand clear when cutting
shipping bands.
Note: Use personal protective equipment as required - Lift smart
using preferred methods. See your Lifting It Right Manual, page
23.
Examine each lift component as you unload it to check for
shipping damage.
