Battery mode
Low battery
Overload
Fault
Bypass mode
Sounds every 4 seconds
Sounds every second
Sounds every 0.5 second
Continuous sound
Sounds every 10 seconds
3-2. LCD panel
3-3. Audible alarm
ON/Mute +
Select button
OFF/Enter
Button
Switch to bypass mode: When the utility power is normal, press
ON/Mute
and
Select
buttons simultaneously for 3 seconds to transfer the UPS to
bypass mode. This action will be ineffective if the input voltage is not within
an acceptable range.
Button
Function
Exit setting mode or return to the upper menu: When the UPS is on setting
mode, press the
ON/Mute
and
Select
buttons simultaneously for 0.2
seconds to return to the upper menu. If it is already in top menu, press
these two buttons at the same time to exit the setting mode
Rack or Tower display switch: Press the
Select
and
OFF/Enter
buttons
simultaneously for 3 seconds. The display changes from/to Rack to/from
Tower.
Rack display
Load info
Load info
Battery info
UPS status
Battery info
Warning and fault info/
Setting operation
Backup
time
info
Input/output
and Battery info
Warning & Fault info/
Setting operation
Backup time info
Input/output
and Battery info
UPS status
Tower display
Load information
UPS status
Battery information
Display
Function
Backup time information
Overload indicator
Indicates the load or the UPS output is short circuited.
Indicates that the programmable management outlets are working.
The UPS is on and supplying utility power to the connected equipment.
Indicates that the UPS is working in converter mode.
Indicates the UPS is working in bypass mode.
Indicates the UPS is supplying power to the loads directly from the mains.
Indicates that the UPS alarm is disabled.
Indicates the battery charger is working.
Low battery level and low voltage indicator.
Battery fault indicator.
Battery level indicator at 0-24%, 25-49%, 50-74%, and
75-100% of its capacity.
BATTERY
25%
50%
75%
100%
Indicates input voltage, input frequency, battery voltage, output voltage
and output frequency. V: voltage, Hz: frecuency
Settings
Input/Output & Battery information
Load information
Display
Indicates the remaining backup time in pie chart.
Function
Backup time information
Fault information
Indicates the remaining backup time in numbers.
H: hour, M: minute.
Warns that an internal fault has been detected.
Indicates that configuration parameters are being set.
Load level indicator at 0-24%, 25-49%, 50-74%, and 75-100%
of its capacity
Warning and fault code indicators. The meaning of the codes is listed
in the section below.
INPUT BATT
OUTPUT
V
Hz
25%
LOAD
50%
75%
100%
Summary of Contents for FDC-1502R
Page 1: ...2 Y e a r w a r r a n t y...
