8. Turn On/Off UPS
Press and hold the power switch on the front panel to start the UPS. The LED lights up when
switch is on. To turn the unit off, simply press and hold the power button until the LED goes off.
9. DC start function
DC Start Function enables UPS to be powered up when AC utility power is not available and
battery is fully charged. Simply press the power switch to turn on the UPS.
10. LCD display
The Forza 1500/2200LCD/LCD-U Series comes equipped with an easy to read LCD and a
blue backlight that displays the battery status, input voltage, output voltage, and operation
mode of the UPS.
When the LCD is initially powered on, the
LCD will display all information at once.
1). When operating in normal mode, the
display appears as shown below.
2).When in AVR mode, it will display as
below. And the mark
will blink once
every second.
3).When in battery mode, it will display as
below. And the mark will blink once every
second.
Note: If I/P-V<40V, input voltage will be
displayed as
000
4).When in off / charging mode, it will
display as below.
Note: the output voltage will always be
displayed as
000
when in off/charging mode.
5).When in fault mode, the display appears
as shown below. Only the
FAULT
indicator
and the reason of the malfunction will be
displayed in this case.
Note: a fault code will appear every time the
UPS enters into the fault mode.
Load
LEVEL
Load bar
Battery \
LEVEL
0%~25%
25%~50%
50%~75%
75%~100%
AC mode
Battery voltage <22.0V
Battery voltage <25.4V
Battery voltage 25.4V
Battery voltage 26.4V
Battery voltage 27.0V
Battery voltage 22.0V
Battery voltage 23.0V
Battery voltage 25.0V
Backup mode
indication
INPUT/BATTERY
(Unit: VDC/Hz/VAC)
OUTPUT/LOAD/FAULT
(Unit: %/Hz/VAC)
LOAD LEVEL
BATTERY CAPACITY
LINE MODE (AVR)
BACKUP MODE
8.) When in overload condition, the icon blinks once every second.
9). When battery is low, the icon blinks once every second.
