5
GB
Cleaning and Maintenance
Important: Before cleaning, the unit should be put into standby and then the power supply should be
turned off at the mains. Please do not plug or unplug the unit with wet hands. Only when cleaning
has been completed and the unit is dry should the cabinet be turned back on at the mains. Using high
pressure water jets or lances is prohibited; the warranty will not cover problems that result from failure
to heed the above warning.
Regular Maintenance:
>
As and when required remove all product and shelving (beware of cold and or sharp components)
from the unit. Clean exterior and interior surfaces with mild liquid detergent, following the directions
on the pack at all times. Rinse surfaces with a damp cloth containing clean water. Never use wire
wool, scouring pads/powders or high alkaline cleaning agents i.e bleaches, acids and chlorines as
these may cause damage. Dry the unit thoroughly before re-using.
>
Cleaning the condenser at least once a month (it is located behind the unitcover); beware of hot
and possible sharp components).
On both the cabinet and counter remove the unit cover securing screw(s) positioned underneath
the front of the unitcover. Pull the cover forward and it will release from the securing pegs to allow
access to the condenser coil.
Once the cover is removed please do not leave the unit unattended. Use a soft brush or vacuum
cleaner to remove dirt/dust. If there are any stubborn grease deposits left on or through the
condenser call your supplier to carry out a full service (this is normally chargeable). Failure to
maintain the condenser may invalidate the warranty of the condensing unit and cause premature
failure of the motor/compressor.
DO NOT
use a wire brush to clean the condenser. Re-fit any panels
removed after cleaning.
>
Door gaskets should be inspected on a regular basis and replaced if damaged. To clean, wipe with
a warm damp soapy cloth followed by a clean damp cloth. Finally thoroughly dry before closing the
door.
>
Shelves, baskets and their supports should be removed to clean. The shelves are dishwasher safe;
however the supports should be cleaned with warm soapy water then rinsed and dried.
Before calling your supplier please make sure that:
a) The plug has not come out of the socket and the mains power supply is on i.e. is the controller
illuminated?
b) Check to see if the unit is in standby
c) The fuse has not blown
d) The cabinet is positioned correctly – cold or warm air sources are not affecting the performance
e) The condenser is not blocked or dirty
f) The products are placed in the unit correctly
g) Defrost is not in progress or required
If the reason for the malfunction cannot be identified, disconnect the electrical supply to the unit and
contact your supplier. When requesting a service call, please quote the model and serial number which can
be found on the silver label located on the inside of the unit (starts E......).
