45
Model D2424LV Reference Manual (Recording Digital Data)
Recording Digital Data
Digital recording from an external digital device
In addition to multirecording by connection to a digital mixer as explained in the separate “Quick
Operation Guide” manual, the following explains the direct digital recording method by connection
to external digital equipment (CD, MD, DAT, adat, etc.).
When recording digital signals from an external digital equipment, digital signals to be input to the
[DATA INPUT]
connector of the D2424LV must be setup for “
S/P DIF
” (S/P DIF digital signals) or
“
adat
” (adat digital signals) in the “Digital Input Setup” menu of the D2424LV SETUP mode.
At the same time, the digital-in clock (Sync mode/async mode) should also be selected and setup
for either sync with external digital signals or with the internal clock. Digital recording can be done
on the currently active program, and “Setup for digital inputs” will be effective on all programs
even when multiple number of programs are currently setup.
• Connecting external digital equipment
1. Interconnect the [DATA INPUT] connector of D2424LV and [OPTICAL OUT] (or adat OUT) connector of the
external digital equipment with an optical cable.
Depending on the digital signal (S/P DIF or adat) to be recorded, the
[DATA INPUT]
connector will function as explained
below.
* If the connected external device has only a COAXIAL (RCA pin) jack for digital output, use an optional
Fostex COP-1/96k (optical/coaxial converter).
OUTPUT
DATA
16 - 9
24 - 17
8 - 1
INPUT
16 - 9
24 - 17
8 - 1
OUTPUT
DATA
16 - 9
24 - 17
8 - 1
INPUT
16 - 9
24 - 17
8 - 1
<Notes on interconnecting>
When using the D2424LV
[DATA INPUT]
connector, it must be set for either S/P DIF digital signals (optical)
or adat digital signals via "Setup of digital inputs" in the SETUP mode. The connector type is the same for
S/P DIF digital signals and adat digital signals but information content of the digital signal is different.
Also, depending on the selected digital signal, each [DATA INPUT] connector will function as explained
below.
<When recording S/P DIF digital signals>
[DATA INPUT] 1-8
only can be used.
By setting the SETUP mode “Setup of digital in-
puts” to "
SPDIF: Async
" or "
SPDIF: sync
," S/P DIF
digital signals that are input to [DATA INPUT] 1-8
will be assigned to tracks 1 and 2 of the D2424LV.
<When recording adat digital signals>
[DATA INPUT] 1-8
,
9-16
,
17-24
can all be used.
By setting the SETUP mode “Setup of digital in-
puts” to "
adat: Async
" or "
adat: Sync
," adat digital
signals input to each input connector will be as-
signed to each track of the D2424LV.
Tracks 1-2
S/P DIF digital signal
adat digital signal
Tracks 17-24
Tracks 9-16
Tracks 1-8
<Important!>
Be sure to input a digital signal (S/PDIF or adat) of the same sampling frequency as that used on the recorder.
<Note>
The [DATA INPUT] connectors of the unit does not support 96kHz FS adat digital signals.
