19
Model VM88 Owner’s Manual
* At output of digital signals to external digital equipment
The formatting (S/P DIF or ADAT Dir) of the digital output signal is setup during setup of DIGITAL OUT via
the setup mode. It is set to S/P DIF in the initial state.
(1) Setup of digital out
Depending on the format setup for S/P DIF or ADAT Dir, the signal output content from the DIGITAL OUT
connector will differ as shown below. To setup of DIGITAL OUT, refer to “Setup mode” on page 33.
* When set to [ADAT Dir]:
Input signals of INPUT 1 ~ 8 that are not affected by the INPUT fader and EQ will be output in digital.
ADAT digital signals at the center of the block diagram below, will be output from the DIGITAL OUT
connector.
ST MASTER
D/A
D/A
To METER
ST MASTER
ST OUT
(-10dBV)
L
R
L R
EFF
ST
1 2
AUX
1 2
LO
HI
10kHz
100Hz
CH ON
1kHz
MID
ST OUT
(-40dBV)
L
R
ST OUT
To MON
To DIGI OUT
CH 1
A/D
LO
HI
PRE/POST
GAIN
PAN
EFF 1
10kHz
100Hz
To DIGI OUT
L R
EFF
TRIM
EFF 2
AUX 1
AUX 2
CH ON
1kHz
MID
ST
1 2
AUX
1 2
CH 2
CH 3
CH 4
To METER
From DIGI IN
INSERT
(-10dBV)
LINE
(+4dBu~-30dBu)
MIC
(+4dBu~-50dBu)
PHANTOM (SETUP)
-48V
< Please remember! >
If the digital output format is set to [S/P DIF], the digital mix signal will be output from the DIGITAL
OUT connector without being affect by the ST OUT ON/OFF switch. However, the signal of a channel
whose mute is switched ON will not be output.
< Please remember the DIGITAL IN status display function >
The DIGITAL IN status indication (DIGITAL, 44.1kHz, 48kHz) in the display will light or blink when the
VM88 is in the status shown below.
48kHz
44.1kHz
DIGIT
DIGITAL
* [44.1kHz] only will light (Initial setup) when the setup mode DIGITAL IN setting is OFF.
* [DIGITAL] will light when the setup mode DIGITAL IN setting is in other than OFF and DIGITAL IN is correctly locked, and
the setup FS ([44.1kHz] or [48kHz]) will be lit.
* [DIGITAL] will blink and [44.1kHz] will be lit when the setup mode DIGITAL IN setting is in other than OFF and DIGITAL IN
is incorrectly locked. In other words, this indicates that the VM88 is operating switched to the internal clock (44.1kHz).
* When set to [S/P DIF]:
The same signal output from the ST OUT L, R connectors (The STEREO L, R mixed signal) will be output
in digital. The S/P DIF digital signal shown at center of the block diagram below will be output at the
DIGITAL OUT connector.
< Please remember! >
If the digital output format is set to [ADAT Dir], the signal will be output from the DIGITAL OUT
connector without being affected by the ST OUT ON/OFF switch and channel mute.
