27
Model VM88 Owner’s Manual
3. Press the [ENTER] key.
The effect type will be finalized, and the
parameter setting screen will appear.
The default (initial) parameter values will be
displayed.
Details on the parameters are given in the
following section, "Parameter settings."
4. To exit Effect Edit mode, press the EXIT key
twice in succession.
You will return to Normal Mix mode.
< NOTE >
When you press the ENTER key to finalize the
effect type, the sound will be muted for an
instant.
Effect parameter settings
Here's how to set the effect parameters.
1. If the effect parameter that you wish to adjust is
not displayed, press the EFF 1 key (or the EFF 2
key) twice.
One of the parameters of that effect type will
appear.
2. Press the EFF 1 key (or the EFF 2 key) several
times to display the desired parameter.
The parameters that appear will differ,
depending on the effect type that is selected.
3. Use the DATA encoder to adjust the value.
For details on the meaning and range of each
parameter, refer to "Effect parameter details"
on the next page.
4. If you wish to adjust another parameter, repeat
from <step 2>.
5. When you are finished making settings, press
the EXIT key twice to exit Effect Edit mode.
<Useful Information!>
The parameter display will change as you re-
peatedly press the EFF 1 (or EFF 2) key. If you
hold down the key for a certain length of time,
the parameter display will go back to the previ-
ous screen.
<Useful Information!>
When the effect parameter being edited is "Delay Time" or "BPM," you can also use the ENTER key or
a foot switch to make the setting by tapping, as an alternative to using the DATA encoder.
In order to use the foot switch for tap input, you need to make settings in the Setup mode "Foot switch
function setting" menu. For details refer to page 33 "Setup mode."
< Note for tap input using the ENTER key / foot switch >
When tap input is used, the value will be finalized on the fourth tap. This means that you must tap
four times or more.
Muting an effect
You can mute the effect sound of effect 1 or effect 2.
To mute the effect sound:
Hold down the EXIT key and press the EFF 1 key
(or EFF 2 key).
The effect sound of effect 1 (or effect 2) will be
muted, and the dry sound will be heard.
When muting is on, the EFF 1 key (or EFF 2 key)
LED will blink.
To cancel muting:
Once again hold down the EXIT key and press
the EFF 1 key (or EFF 2 key).
The dry sound will change back to the effect sound.
When mute is turned off, the EFF 1 key (or EFF 2
key) LED is off.
<Useful Information!>
Effect muting can also be switched on/off by a foot switch (separately sold) as an alternative to the
above procedure.
The foot switch can be used to switch muting on/off for effect 1 or effect 2, or can simultaneously mute
both effect 1 and effect 2. For details refer to page 33 “Setup mode.”
