After the flame burning, please comply with Fig. 4 5 6 7 method to turn Mark 1 knob and
comply with Fig. 4 5 6 7 8 method to turn Mark 2 knob. You can adjust big or small fire
according to the demands.
If you need to stop stove working, please clockwisely turn the knob to " " position, then the
fire will be extingushed (refer to Fig. 3). Then close the general gas valve.
6
5
方太嵌入式电 烤 箱
■
Check
Notice
Cleaning and Maintenance
OFF
ON
Please contact FOTILE
service center if there is
abnormity.
a.The flame failure device can prevent the gas leak accident caused by fire
extinguishing, which is due to wind blow or soup overbrim. But it can’t avoid
gas leak due to other reasons.
b.All FOTILE gas stoves are with flame failure device.Press down the knob
when igniting,and anticlockwisely turn to " " position(refer to Fig. 5).It is ok if
the flame will not extinguish after you loosen your hand, which means the
flame failure device is working now. When cooking, if the overbrimed food or
blowing wind extinguish the flame accidently, the device will close the gas
valve automatically to avoid the gas leak.
Soap-Suds
Before cleaning and maintain-
ing the stove, switch off the
general gas valve and wait for
it cooling down thoroughly.
When you maintain the follow-
ing, make sure not disassem-
bly the safety device or gas
duct parts.
The gas link rubber hose
must be reliable and avoid
any cracks; once you find
gas leak, please stop using
at once and replace it in
time.
Please don't stack the
inflammable around the
gas stove.
Burners, flame caps and pan
supports shall be correctly
positioned.
Check the interfaces with suds
frequently to avoid gas leak.
The flame should not be
irregular.
Never let the spilth block
the burner. Make sure
there is no food residua,
foreign matter and water
touch the ignition and
thermocouple head.
Please don't wipe the stainless steel panel with sharp material like steel wire ball, etc.
It will greatly shorten the stove lifespan.
(Fig. 3)
(Fig. 4)
(Fig. 5)
(Fig. 6)
(Fig. 7)
(Fig. 8)
Mark 1
Mark 2
GAS STOVE
Fire Adjustment
First of all, check whether knobs is in the “ ” position(refer to Fig.1 A). Then turn on the gas
switch, press the stove knobs, contrarotate 90 degrees(refer to Fig.1 B), to confirm the flame
is lighing up. If the flame extinguishes after your hand off the knobs, then please return the
knobs to “ ” position, and repeat the above operations.
