F2X46-DK Series IP Modem User Manual
Xiamen Four-Faith Smart Power Technology Co.,Ltd
.
Add
：
Floor 11, Area A06, No 370, chengyi street, Jimei, Xiamen.China
Page 18 of 33
Fax
：
0592-5912735
Tel
：
0592-6300320
Hotline
：
400-8838-199
status bar above the configuration software if it query successfully.
6
、
Click the tree menu on the left of the screen, the information window in the middle of
the interface will display the configuration information under the tree menu, especially click
the level 1 tree menu. All the configuration information is displayed in the information
window, where you can view all the configuration information through the drop-down scroll
bar.
3.2 Configuration options
The configuration content of each configuration is described below
3.2.1 “Local serial port Settings”
Serial port baud rate
：
1200
、
2400
、
4800
、
9600
、
14400
、
19200
、
38400
、
57600
、
115200(bps) (Option) ;
115200 (Default)
Serial port data bits: 8
Serial port stop bits: 1
、
1.5
、
2 (Option)
Serial port parity bits: None/odd/Even
Local serial port scan interval (100 ms):10 (Default)
Packet response timeout (seconds): 5 (Default)
Local serial port frame size (bytes): 1024 (Default),set optionally, Range:
：
(10~1024)
3.2.2 “Local serial port 2 Settings”
Serial port baud rate: 1200
、
2400
、
4800
、
9600
、
14400
、
19200
、
38400
、
57600
、
115200(bps) ;
9600(Default)
Serial port data bits: 8
Serial port stop bits: 1
、
1.5
、
2 (Option)
Serial port parity bits: None/odd/Even
Local serial port scan interval (100 ms):10 (Default)
Packet response timeout (seconds): 5 (Default)
Local serial port frame size (bytes): 1024 (Default) ; set optionally; Range:
：
(10~1024)
Note
：
1
、
Local serial port is usually used for configuration. Local serial port 2 is
used to transfer data and support configuration function.
2
、
For data ports, changes can be made through the software version.
3.2.3 “DTU Working mode Setting”
Whether to connect the support platform
:
Yes or No(If chose “No”, the item "Support
platform related Settings" is invalid, do not need to set it. In general, choose "No", to use the
