F7B3X Series Router User Manual
Xiamen
Xiamen
Xiamen
Xiamen Four-Faith
Four-Faith
Four-Faith
Four-Faith Communication
Communication
Communication
Communication Technology
Technology
Technology
Technology Co.,Ltd.
Co.,Ltd.
Co.,Ltd.
Co.,Ltd.
Page 14 of 81
Add
:
J1-J3,3
rd
Floor,No.44,GuanRiRoad,SoftWare Park,XiaMen .361008.China
http
:
//www.fourfaith.com
Tel
:
+86 592-6300326
6300325
6300324
Fax
:
+86 592-5912735
Installation
Installation
Installation
Installation of
of
of
of SIM/UIM
SIM/UIM
SIM/UIM
SIM/UIM card:
card:
card:
card:
SIM/UIM-1: For the main link
SIM/UIM-2: For the backup link
Model
SIM/UIM Type
F7B30 GPS+TD-SCDMA/TD-SCDMA ROUTER
SIM/UIM-1: TD-SCDMA (main link)
SIM/UIM-2: TD-SCDMA (backup link)
F7B31 GPS+EVDO/EVDO ROUTER
SIM/UIM-1: EVDO(main link)
)
SIM/UIM-2: EVDO(backup link)
F7B32 GPS+WCDMA/WCDMA ROUTER
SIM/UIM-1: WCDMA(main link)
SIM/UIM-2: WCDMA(backup link)
F7B33 GPS+WCDMA/EVDO ROUTER
SIM/UIM-1: EVDO(main link)
)
SIM/UIM-2: WCDMA(backup link)
)
F7B34 GPS+EVDO/TD-SCDMA ROUTER
SIM/UIM-1: EVDO (main link)
SIM/UIM-2: TD-SCDMA (backup link)
Firstly power off the router, and press the out button of the SIM/UIM card outlet with a needle
object. Then the SIM/UIM card sheath will flick out at once. Put SIM/UIM card into the card
sheath (Pay attention to put the side which has metal point outside), and insert card sheath back to
the SIM/UIM card outlet.
Warning:
Warning:
Warning:
Warning:
Forbid to install SIM/UIM card when powered!
Installation
Installation
Installation
Installation of
of
of
of antenna:
antenna:
antenna:
antenna:
ANT-1: For the main link
ANT-2: For the backup link
Screw the SMA male pins of the two cellular antennas to the female SMA interfaces of the
router with sign “ANT-1” and “ANT-2”.
Screw the SMA male pin of the GPS antenna to the female SMA interface of the router with
sign “GPS”.
Warning: The cellular antenna and the GPS antenna can not be connected wrongly. And the
antennas must be screwed tightly, or the signal quality of antenna will be influenced!
Installation
Installation
Installation
Installation of
of
of
of cable:
cable:
cable:
cable:
Insert one end of the network cable into the switch interface with sign “Local Network”, and
insert the other end into the Ethernet interface of user’s device. The signal connection of network
direct cable is as follows:
RJ45-1
RJ45-2
1
1
2
2
3
3
4
4
5
5
6
6
7
7
8
8