20 Chapter
1
DaqPRO
1.2.5.
Load the Last Setup
When you turn
DaqPRO
on, once the self-testing has been completed, the following will be displayed:
_ _ _ I N I T I A L I Z A T I O N _ _ _
D a q P R O v e r 3 . 0 h
I n i t . D i s p l a y
I n i t . R A M
L o a d i n g S E T U P …
The last setup is then automatically loaded.
1.2.6.
Configuring your DaqPRO
Use the
System Configuration
menu to select the thermocouple temperature compensation method, to
select number of averaging points, to set temperature units, to clear the
DaqPRO
’
s memory or to
change the screen contrast.
In the
MAIN MENU
screen, select the
System Configuration
icon
to display the configuration
screen:
_ _ _ C O N F I G U R A T I O N _ _ _
→
I n t
C o m p e n s a t i o n
A v e r a g e 4 s a m p l e s
T e m p e r a t u r e
i n
°
C
C l e a r m e m o r y ( > )
C o n t r a s t ( < ) ( > )
Use the
Forward
and
Backward
arrow
buttons to select the mode and then press the
Press the
Enter
button
to move to the next item. You can press the
Escape
button
to
leave the configuration menu at any time, saving the new changes you made. Press the
Enter
button in
the last item (Contrast) if you want to go back to the first item (Compensation).
The new configuration will be saved until the next time you change it.
www.esis.com.au
Ph 02 9481 7420
Fax 02 9481 7267
esis.enq@esis.com.au
