1. Connect the alarm to a suitable USB power supply (vehicle USB, powerbank etc). If working normally a red LED light will be shown.
2. Place the bike rack on your vehicle in the desired location. Turn on the N-Power control box. At this time the alarm should ring and the automatic vacuum pump should be
operating. Press the rack down on the surface of your vehicle while the pump runs. The system will create a vacuum to fasten the rack in place and will automatically stop once
the pressure is correct. With the pressure correct and the rack firmly in position the alarm will automatically shut off.
3. With the front portion of the rack installed you can now fit your bike. Remove the front wheel of your bike and carefully lift it into position. Use the appropriate axle adaptors to
clamp your fork in place. Warning! Please ensure all boils are fully tightened to prevent accident, damage and unwanted vibration.
4. With your bike in place you will now be able to choose the perfect location for the rear suction foot and wheel locator. Press the suction foot in place by hand then connect the
pneumatic air hose to the N-Power control box. The alarm will once again sound, but will stop once the correct pressure is achieved. If you plan to carry additional bikes, follow
this stem again but connect additional hoses to the main suction foot.
5. With the rear suction foot in place sit the rear wheel into position and use the buckle to secure in place.
6. We recommend that you use a strap to keep your crank arm in place while driving. This will prevent the crank moving and causing damage in transit.
7. Once your bike/s are in position give the entire system a final check. Ensure that all suction cups are secure and that there are no leaks, Also ensure that the fork axle is secure,
the bike isn't moving. Also strap your wheels and crank to prevent movement.
8. To remove the rack first remove your bike. Switch the N-Power control box off then lift the edges of the suction foot to break the air seal to your vehicle. The rack will then easily
lift away from your vehicle.
9. When not in use store the rack in a clean box and ensure that the suction cups are not damaged or deformed.
Instructions
17
Installation
Correct
Wrong
