GB
5
EVO XS
GB
4
EVO XS
Holding the tips of the aluminium poles, fan the Evo XS
out as shown.
Assembly Instructions
1.
The solid bosses should be fitted to the
tip of each of the side poles. Each pole
should be fitted so that the bosses have
the pair of sockets facing towards the
front of the Evo XS. Picture shows the
boss fitted to the left hand pole with
sockets facing in correct position.
2.
Taking the short centre pole,
place it into the socket on the
block opposite to where the
side pole is connected.
3.
Tension the Evo XS and
connect the centre pole into
the other boss.
4.
Insert the two rear poles into
the boss sockets as shown.
5.
Standing at the front of the Evo XS, take hold of one of the short
front poles and placing downward pressure onto the boss, insert
the pole into the socket with the cut away. This is best done using
a light downward pressure on the boss, while lifting and inserting
the pole with the other hand.
6.
Repeat the process for the
remaining front pole.
7.
Summary of Contents for Evo XS
Page 1: ......