42
1.
Open the base of the table saw (
Fig. 1
). Follow this procedure regarding the arrangement
of the base (see par. “Folding of the base”) in reverse order. Please note that the legs can
be folded only if the locking device is disconnected by pulling the legs. (
Fig. 2
). Be sure that
the legs are locked in the correct position when the base is completely folded.
2.
Fix the two transport wheels to the base, by using the fasteners (29), the four screws
M6x40 mm and the corresponding screws and washers (
Fig. 3 and 4
).
1.
Place the table saw in the desired position.
2.
Loosen the lock nut of the adjustable foot (
Fig. 5
) (30) and tighten or loosen it until the
workbench is flat (
Fig. 6
).
3.
Tighten the lock nut of the adjustable foot.
1.
Use the two screws M6x12 mm with the corresponding washers to fix the workbench’s
back extension (24) to the bench (1).
2.
Use two screws M6x12 mm with the corresponding washers and nuts to fix the bearings of
the workbench’s back extension (28) to the external angle of the workbench’s back
extension (24) (
Fig. 7 and 8
).
3.
Fix the bearings of the workbench’s back extension (28) by inserting the self-drilling screws
17 mm in the holes located on the sides of the supporting structure of the table saw (
Fig.
9
).
4.
Check if workbench’s back extension is parallel to the supporting structure and at grade of
the workbench, and adjust it if necessary.
WARNING: BEFORE PERFOMING TASKS OF AY KIND BE SURE THAT THE
MACHINE IS DISCONNECTED FROM THE SOCKET.
1.
Remove the self-drilling screw located at the end of each bolt of the back extension (25).
2.
Loosen the two locking screws (26) and let the bolts of the back extension slide in the holes
located under the workbench (
Fig. 10 and 11
).
3.
Insert the side extension completely and replace the self-drilling screws.
4.
Adjust the side extension in the desired position and tighten the two locking screws (26).
5.
Repeat the same operations for the other side extension.
ASSEMBLY OF THE BASE
ADJUSTMENT OF BASE’S HEIGHT
ASSEMBLY OF THE BACK EXTENSION OF THE WORKBENCH
ASSEMBLY AND ADJUSTMENT OF THE SIDE EXTENSIONS
Summary of Contents for F36-521
