7310 Installation and User’s Guide
Appendix IV 7100M Chassis
Figure 31 - 7100M Chassis Rear View
10.2.4 Connecting the Back Panel Jumpers
On the rear panel of the 7100M Back Panel are product connectors (JP1 to JP4). The 3 pin connectors (male) are the
connecting point between the slots and the back panel. One pin is for the Tx/Rx, one is for the 2000 RF Switch, and one is
for the 7100M. A 2 pin jumper (female) is placed on the relevant pins to complete the connection between the 7100M and
the units. For example, if a 2000 RF Switch is being used, the jumper is placed on the Switch-7100M pins.
To connect the jumpers:
1. Each jumper has two sets of pins, upper and lower. The upper pins are labeled SW (Switch) and the lower pins Tx/Rx
(Transmitter/Receiver).
2. If the 7100M has Tx or Rx units only, place all jumpers on the lower two pins.
Foxcom Proprietary Information
54
Document No. 93-005-39-A1
