Chapter 3 BIOS Description
41
v
Wake-Up by PCI card
This option is used to set the system to wake up by PCI card.
v
Power On by Ring
If this item is enable, it allows the system to resume from a software power
down or power saving mode whenever there is an incoming call to an installed
fax/modem. This function needs to be supported by the relevant hardware and
software.
v
USB KB Wake-Up From S3
This option is used to set the system to wake up by USB equipment when it is
in S3 (Suspend to RAM) mode.
v
Resume by Alarm
This option is used to set the timing of the start-up function. In order to use this
function, the start-up password function must be canceled. Also, the PC power
source must not be turned off.
v
Date (of Month) Alarm
This option is used to set the timing for the start-up date. The setting values contain
0-31.
v
Time (hh:mm:ss) Alarm
This option is used to set the timing for the start-up time.
v
Primary IDE 0/1, Secondary IDE 0/1
When these items are enabled, the system will restart the power saving time-
out counters when any activity is detected on any of the drives or devices on the
primary or secondary IDE channels.
v
FDD, COM, LPT Port
when this item is enabled, the system will restart the power saving time-out
counters when any activity is detected on the floppy disk drive, serial ports, or
the parallel port.
v
PCI PIRQ[A-D]#
When this option is disabled, any PCI device set as the Master will not power
on the system.
文件使用
"pdfFactory"
试用版本创建
