time synchronization of multiple small cells.
1)
REM Enable – Boolean value to toggle function on and off
2)
REM Band List – A band that is being broadcast from a microcell in your area to which
small cell can listen to for the time sync function. For example, band 48
3)
REM EARFCN – Absolute Radio Frequency Channel Number. Select a list of
frequency channel numbers that are supported both in your area and by the band that
was selected above. Leaving this section blank will greatly increase the time to find
an available Macro cell. (approximately 2 hours).
Figure 3.7 REM Configuration
3.4.2 Gateway Configuration
The Small Cell needs to be in constant contact with the EPC via an inform method. This
inform method carries with it the connection information, configuration options and general
Small Cell data. When the small cell needs to make a configuration change or status check, the
small cell should update the EPC. When the Small Cell needs to check in with the EPC, the
Small Cell checks the ShareRan configuration option to find the address.
1)
IPAddress: The Gateway IP address is set to the static IP of the EPC. Ex: 10.20.46.54
2)
PLMNList: Public land Mobile Network list is used by the User Equipment (UE) to select
the small cell that it will connect with.
Figure 3.8 shareRAN Configuration
3.4.3 NTP Configuration
Specify the Network Time Protocol (NTP) server for the Small Cell, so that the system
time of the Small Cell can be synchronized.
Summary of Contents for T99B226
