7
www.
foxtechfpv
.com
Please check the connection status by following steps after the connection is
completed.(This step will have some differences because of different flight controls.)
1.
Open the
PC device manager and you can see that the ground unit is correctly
recognized, the driver is installed correctly, and there is no yellow exclamation
mark.
2.
Open the
FC ground station software,select the corresponding COM port, and connect to
the flight controller.
The flight control is connected normally,indicating that the RB20 digital
transmission link
is connected. If the connection fails, please check the following points.
1.The baud rate of the flight controller is
same as the baud rate of RB20.
2.Ensure that the
RB20 ground unit driver is installed successfully.
3.Use the
RB20 parameter setting software to ensure that all parameter
settings for
RB20 air and ground unit are consistent.
4.
Ensure that RX of FC to TX RB20,TX of FC to RX RB20.
3.
Open the rc setting interface of the ground station to check whether the remote
control data is normal. If the remote control data changes normally
along with the
joystick. The remote control link is connected. If the remote control connection fails,
please check if the “-, +, signal” of the S-BUS is reversed.
