age supplied is the same as that one specified
on the nameplate of the tool. To use a not
specified voltage may cause a serious injury to
the user as well as damage the tool.
TOOL USE AND CARE
Do not force the power tool. Use the correct
tool for the application. The correct tool will
do the job better and more safely at the rate
that it was designed to work at.
Do not use tools if switch does not turn it on or
off. Any tool that cannot be controlled whith
the switch is dangerous and must be repaired.
Disconnect the plug from the power source
before making any adjustments, changing ac-
cessories or storing the tool. This preventive
safety measures reduce the risk of accidental
starting of the tool.
When the power tool is not in use, store it out
of the reach of children, and do not allow in-
dividuals who are not familiar with the power
tool or these instructions to operate it. Power
tools are dangerous in the hands on untrained
users.
Maintain the power tool. Check for misalign-
ment or binding of moving parts, broken parts,
and any other condition that may affect the
operation of the power tool. If it is damaged,
have it repaired before using. Many accidents
are caused by poorly maintained power tools.
Check for misalignment or bonding of moving
parts, breakage parts, and any other condition
that may affect the tools operation. If you find
a damaged tool, take it to service before use it.
Use only accessories that are recommended by
the manufacturer of your model. Suitable ac-
cessories for one tool, may become hazardous
when are used on another tool.
Keep cutting tools, sharpened and clean. Cut-
ting tools in good condition with sharpened
edges, are less likely to stuck in workpieces or
easier to control.
Is recommendable to use a safety device suit-
able, such a thermal and diferential switch
when you are using an electric equipment.
SERVICE
Tool service must be perfomed only by quali-
fied repair personnel. Service or maintenance
performed by unqualified personnel could re-
sult in a risk of injury.
SPECIFIC SAFETY RULES FOR
ORBITAL SANDERS
• Never leave the switch of the ignition in the
position ON, before plugging the machine assure
that the switch is locked in the position off.
• When it starts up the machine let it run for
some minutes before using it in the work piece.
Look at the vibration or wave that it can indi-
cate a poor installation.
• Assure the material to be worked. Never hold
it witch your hand or with your legs.
• Maintain your hands far from mobile parts.
• Always wear eye protection and mask, es-
pecially when you are working at the level of
your head.
• Do not touch the work pieces immediately
after the operation it can be terribly hot and it
can burn your skin.
• This sander is not designed for carry out wet
sandy.
• The inhalation dust is danger for your health.
Is recommend always use the system of extrac-
tion dust, for this connect the suction hose of
vacuum cleaner to connector of vacuum clean
leave for extraction of the sander using adapt-
ing when is necessary.
• Use a dust mask when you are working this
tool.
• Holes in sanding paper and base must be
aligned
• Never apply extra force on the machine when
you are working.
• Make sure the piece of work. Use a clamp
or any unit for support the piece of work, this
is safe that uses your hands and let have free
your hands for uses the machine.
FEATURES
KNOW YOUR TOOL
Before at-
tempting to
use this prod-
uct, become
familiar with
all of its oper-
ating features
and safety
requirements.
9
E N G L I S H •
User’s manual
2
4
3
1
LO313 manual.indd 9
23/06/15 10:03
