Expansion modules
63
In the process branch, current values of a S0 module are only
displayed if there is a corresponding configuration. In addition
to the module identification (Module), a definition of the oper-
ating mode (Mode) is mandatory.
Default values exist for the remaining configuration entries.
Example 1:
S0 module (fixed soldered) with 3 channels has module address
0x
3E
(bus
0
).
Channel 1 = absolute counting
Channel 2 = relative counting
Channel 3 is not used.
Scaling for channel 2 with (4/1). Synchronisation every 5 minutes (300s):
<!-- The range 0 - 4095 is scaled to 0 - 2000 in this case -->
[<SetConfig _="PROCCFG" ver="y">
<Periphery>
<Module Name="S0 (PIC)" Address="
C
0
3E
">
<Mode _="
abs,rel,off
"/>
<SyncPeriod
_="
300
"/>
<Numerator1
_="
1
"/>
<Denominator1
_="
1
"/>
<Numerator2
_="
4
"/>
<Denominator2
_="
1
"/>
<Numerator3
_="
1
"/>
<Denominator3
_="
1
"/>
</Module>
</Periphery>
</SetConfig>]
SyncPeriod
900
NumeratorX, DenominatorX
1
StartValueX
0
Summary of Contents for 50.0070.0001.00
