Configuration manual FP S-ENGuard
8
2
For your safety
Please read these safety instructions carefully before configuring the device.
Make sure that you have understood all instructions.
For installation and safe use, read the basic instructions in the “Installation and Safety”
manual of the FP S-ENGuard model.
2.1
Intended use
FP S-ENGuard devices are gateways, i.e. remote communication computers.
Possible applications are remote maintenance, reporting of faults, data logging or the
use as an internal web server.
Use FP S-ENGuard only for applications that comply with the device specification.
Observe the specified characteristics.
When configuring the device, observe the safety and accident prevention regula-
tions applicable for the specific application and location.
Operate FP S-ENGuard only as described in the “Installation and Safety” manual
and this configuration manual.
Do not carry out any unauthorised interventions in the hardware and software.
2.2
Safety instructions for working on an already installed FP
S-ENGuard
Hazardous areas with live parts
When working on an already installed FP S-ENGuard, there are areas where there is a
hazard of electric voltage. Inside the device there are live parts behind a protective
cover for the mains supply.
– Danger to life from electric shock when touching live parts.
– Risk of injury from startled reactions when touching live parts.
– Danger of injury by triggering an electrical arc.
Avoiding danger from electrical voltage
Carry out the following safety measures to avoid hazards due to electrical voltage.
Before removing the protective cover for the power supply inside the FP S-ENGuard:
Disconnect the device from the power supply.
Secure it against restarting.
Keep unauthorised persons away from the device.
Summary of Contents for 50.0070.0001.00
