If the battery power is low,
< >
will
appear and blink on the LCD panel.
Please replace the batteries
immediately.
19
Using the Wide Angle Diffusion Panel
Low Battery Warning
Pull out the wide angle diffusion
panel and place it over the flash head
as shown. The flash coverage will then
be expanded to 14 mm.
The catchlight panel will come out
at the same time. Push the
catchlight panel back in.
The
< ZOOM/C.FN >
button will
not work.
The following table lists the available and unavailable custom
functions of this flash.
1. Press
< Zm/C.Fn >
Backlight/Custom Setting Button for 2 seconds
or longer until C.Fn menu is displayed. The “Ver x.x” in the top-right
corner refers to the software version.
2. Select the Custom Function No.
Turn the Select Dial to choose the Custom Functions.
3. Change the Setting.
Press
< SET >
button and the Setting No. blinks.
Turn the Select Dial to set the desired number. Pressing
< SET >
4. In the C.Fn mode, long press the “Clear” button for 2 seconds until
“OK” is displayed on the panel, which means the values in C.Fn can
be reset.
C.Fn: Setting Custom Functions
m/ft
APO
AF
Sv APOT
BEEP
LIGHT
LCD
m
ft
ON
OFF
ON
OFF
60min
30min
ON
OFF
12sec
OFF
ON
0~9
meters
feet
ON
OFF
ON
OFF
60min
30min
ON
OFF
Off in 12 sec.
Always off
Always lit
10 levels
C.Fn Custom Functions
Custom
Function
Signs
Setting
No.
Settings &
Descriptions
Distance indicator
Auto power off
AF-assist beam
Slave auto power
off timer
Audible
ready alert
Backlighting time
LCD contrast ratio
Function