Part No. 26984 Rev. C May 2018
- 16 -
Refrigerated Milk Drawer
INSTALLATION
Regulations
REFRIGERATED CABINETS
-
INSTALLATION
Compliance
with Local
Requirements
It is very important that your cabinet is installed correctly and that the operation
is correct before use. Installation must comply with local electrical, health &
safety and hygiene requirements.
Setting Up
REFRIGERATED CABINETS
-
INSTALLATION
Unpacking
Unpack and check unit for damage and report any damage to the carrier and
supplier. Report any deficiencies to your supplier.
The cabinet is supplied fully assembled.
Positioning the
Cabinet
Ensure the cabinet location and any bench cut-
outs are made to the precise measurements
shown in the Mechanical Drawings.
Position the cabinet in its allocated working
position. Adjust each foot to set the height,
ensuring the cabinet is level from side to side
and front to back. (If this is not carried out, water
may accumulate in the cabinet well, and uneven
temperature distribution could also occur).
Support Bolt
To ensure stability of the cabinet
when the drawer is open, the
threaded plastic bolt must be
screwed upwards to contact the
joinery above the cabinet.
The legs must be adjusted
before the support bolt is
tightened.
Open or remove the drawer to access the support bolt, which is located at the
center-back of the cavity.
Rotate it clockwise until it contacts the joinery, using finger pressure only.
Continued on next page
