Part No.26118 Rev. H September 2018
- 12 -
Inline 3000 Series Cabinets
CLEANING
A wall chart is included at the back of this manual. It contains step-by-step instructions for every
day cleaning of your cabinet. However, please read the following additional information.
Cautions
HEATED CABINETS
-
CLEANING
Power
ALWAYS TURN THE POWER SUPPLY OFF BEFORE CLEANING.
Water
THIS UNIT IS NOT WATERPROOF. DO NOT USE A WATER JET SPRAY TO
CLEAN THE INTERIOR OR EXTERIOR OF THIS CABINET.
Exterior
HEATED CABINETS
-
CLEANING
Metal Surfaces
Stainless steel or aluminium surfaces should be cleaned with hot soapy water or
a good quality metal cleaning compound. DO NOT clean surfaces with abrasive
pads or cleaners (e.g. Scotchbrite pads or Jif), as paint, stainless steel and
aluminium surfaces will be damaged.
Glass
All glass should be cleaned using a good quality glass cleaner and a clean
cloth.
DO NOT
use abrasive pads or cleaners, because they will damage the surface
of the glass.
Sliding Doors
Sliding glass doors are located by plastic guides at the
top and bottom.
The doors can be removed for cleaning by sliding the
door to a central position, placing hands either side of the
door, lifting it up and then swinging it out at the bottom.
When replacing doors, make sure that they are located in
the correct slots, top and bottom. The left door should be
in the inner slots, and the right door in the outer slots.
Sliding door tracks should be vacuumed out regularly to
keep doors sliding freely.
Continued on next page
