IN 3H06/09/12/15
- 17 -
© Future Products Group
Lighting
cont.
HEATED CABINETS - SERVICING
LED Strip
Replacement
Individual LED modules cannot be
replaced. A complete light unit must
be used.
Connection is made with a plug and
socket. Disengage the supply lead
from the metalwork, and re-assemble
it to the replacement unit.
Heating
HEATED CABINETS
-
SERVICING
Caution
DO NOT attempt to replace heating elements without isolating the cabinet
at the supply switch or by unplugging it from the mains supply.
Element
Replacement
CAUTION:
This must only
be carried out by
a qualified
service person.
Remove the doors and base
trays from the cabinet, to
reveal the heating elements.
To access the element
terminals, remove the screws
securing the element to the
rear bulkhead. Unclip the
element from its support
brackets and withdraw it to
reveal the connections.
Disconnect the old element, connect the replacement, taking care to replace
and refit any insulation material. Position the new element against the
bulkhead, clip it into the support brackets and replace the two fixing screws.
Test
Turn the power on and test the heating operation. If the heating is now working,
replace the steel connection covers and re-assemble the base trays and doors.
If normal operation cannot be restored, by replacing the element, other circuit
elements will have to be checked, see Fault Finding.
Caution
Do not run the cabinet heaters for extended periods, without the base
trays in position. Directly radiated heat may otherwise damage the lower
light fittings.
