Copyright © 2018 FPVMODEL LIMITED
5
BATTERY CONNECTION
Battery connection is easy and straight forward. Ground goes to ground and positive goes to positive.
RECEIVER CONNECTION
Your Betaflight F7 can use a wide variety of receivers. Since this board is an F7 there is no need to use
locations that have inverter or do not have inverter based on your receiver type, F7 can accept either inverted
or non-inverted signals. Caution should be used, depending on receiver type, when it comes to voltage. If
your receiver requires 3.3v power input use the pad labeled 3V3 if your receiver requires 5V use the pad
that says 5V. Signal pad can accept SBUS, IBUS, DSM2. The signal pad is UART6 RX.
