1
ENGLISH
5.5 HEADEND SETUP AND KTP EMULATION MENU
This menu concerns advanced programming that foresees the connection of several modules by RJ45 jumpers.
Procedure to modify the modulator address in the event of use of several modules connected to one another:
enter the “SETTINGS” – “SET ADDRESS” menu;
set the headend address number by using the arrows;
on the TPE display, the word “Wait …” will appear (the wait can last up to 0 seconds);
scan the modules: SETUP HEADEND --> SCAN HEADEND;
the TPE checks the modules present in the headend; when the number of installed modules is reached, press the “X”
key of the TPE;
enter the “HEADEND SETUP” menu;
save with the TPE “S” key.
•
•
•
•
•
•
•
HEADEND
SETUP
HEADEND SCAN
FACTORY SETUP
SET ADDRESS
RESET MODULE
Search Module….
KM/KMM/KMS
All
modules
NAVIGATION
COPY
KM/KMM/KMS
Y ES=V
NO=X
Change address
Current: xxx
New: xxx
Y ES=V
NO=X
OSD NAVIGATION
KM/KMM/KMS
(Not av ailable)
KM/KMM/KMS
KM/KMM/KMS
Y ES=V
NO=X
KM/KMM/KMS
KM/KMM/KMS
All
modules
KTP
EMULATION
KTP
EMULATION
V=OUTPUT
Nav igation in the headend
programming menus
Automatic
acknowledgement of the
headend connected to
the TPE
Restore the headend def ault
settings.
The address of the
module is reset to 000.
Automatic search of the headend or
connected dev ice. Af ter searching,
the main menu can be seen f rom
the NAVIGATION f unction.
Ref er to the general
programming menu of the
KM modulator
Select the new address
by the up/down arrows.
Conf irm by pressing
the V key .
Emulation of the
KTP programmer
This f unction is not av ailable
f or the programming of the
KM modulator
Copy
Paste
KTP Emulation
Manual setting of the
headend address.
Export the headend configuration to
another one.
Av ailable only when
the module address is not 000
